Is your Hayward pool pump motor not working properly? It might be time to change it. Changing the motor of your Hayward pool pump is a relatively straightforward process that you can do yourself with the right tools and knowledge. In this guide, we will walk you through the step-by-step process of changing the motor of your Hayward pool pump.
Step 1: Gather the Necessary Tools
Before you begin changing the motor of your Hayward pool pump, make sure you have all the necessary tools on hand. Here is a list of tools you will need:
- Socket wrench set
- Flathead screwdriver
- Phillips screwdriver
- New Hayward pool pump motor
- New motor seal kit
- Thread sealant
- Shop towels
- Work gloves
Credit: intheswim.com
Step 2: Turn Off Power to the Pump
Before you start working on your Hayward pool pump motor, make sure to turn off the power to the pump at the circuit breaker to avoid any accidents or injuries.
Step 3: Remove the Pump Housing Cover
Using your socket wrench set, remove the bolts that secure the pump housing cover in place. Once the bolts are removed, carefully take off the cover and set it aside.
Step 4: Disconnect the Motor Wiring
Locate the motor wiring attached to the motor and carefully disconnect the wires. Make sure to label the wires or take a picture of the wiring configuration to ensure you can reconnect them correctly later.
Step 5: Remove the Old Motor
Using your socket wrench set, loosen the bolts that secure the old motor to the pump housing. Once the bolts are removed, carefully lift out the old motor and set it aside.
Step 6: Install the New Motor
Place the new Hayward pool pump motor in the pump housing and secure it in place with the bolts from the old motor. Make sure the motor is properly aligned before tightening the bolts.
Step 7: Reconnect the Motor Wiring
Reconnect the motor wiring to the new motor following the labeling or picture you took earlier to ensure the correct connections.
Step 8: Replace the Pump Housing Cover
Place the pump housing cover back on the pump and secure it in place with the bolts using your socket wrench set.
Step 9: Apply Thread Sealant
Apply thread sealant to the threads of the pump housing cover bolts to prevent any water leakage once the pump is back in operation.
Credit: www.youtube.com
Step 10: Turn On Power to the Pump
Once everything is securely in place, turn the power back on at the circuit breaker and test the new motor to ensure it is functioning properly.
Step 11: Check for Leaks
After the new motor has been installed and the pump is running, check for any leaks around the pump housing cover. If you notice any leaks, tighten the bolts further or reapply thread sealant as needed.
Step 12: Enjoy Your Pool!
With your new Hayward pool pump motor successfully installed, you can now enjoy a properly functioning pool pump that will keep your pool clean and ready for swimming all season long.
Changing the motor of your Hayward pool pump is a task that can be completed with a little time and effort. By following these steps and having the right tools on hand, you can save money on professional installation and ensure your pool pump is working efficiently.
Remember, safety always comes first when working with electrical components, so make sure to turn off the power before starting any work on your pool pump motor. If you ever feel unsure or uncomfortable about changing the motor yourself, it’s always best to consult a professional for assistance.
Now that you have the knowledge to change the motor of your Hayward pool pump, you can keep your pool in top condition and enjoy a refreshing swim whenever you desire.
